Skip to main content
(828) 649-7190
Same Day Shipping Before 2pm EST

Metric V-Belt Size Chart: SPA, SPB, SPC & SPZ Profiles

Compare SPZ, SPA, SPB and SPC metric V-belt profiles, understand metric length markings, and shop matching stocked sections.

Metric V-belts use standardized cross-sections and length designations intended for matching metric sheaves. The common SP families stocked here are SPZ, SPA, SPB and SPC. The letters identify different wedge profiles; the number is part of a metric belt designation, not a universal inch-length conversion.

Metric SP V-belt profiles

ProfileTypical marking exampleSelection check
SPZSPZ1000SPZ groove and the specified metric length.
SPASPA1950SPA groove and the specified metric length.
SPBSPB1250SPB groove and the specified metric length.
SPCSPC2000SPC groove and the specified metric length.

The profile codes represent different cross-sections. Use the belt manufacturer’s dimensional chart and the sheave specification to confirm the exact groove; do not choose by length digits alone.

Understand metric belt length

Metric belt numbers may be based on datum/effective length under the applicable standard. They do not necessarily convert directly to the outside circumference measured with a tape. If the marking is worn away, record the profile, measure the belt with an appropriate belt gauge, and compare it with the drive maker’s part number or a verified cross-reference.

Metric vs. inch-series belts

An SP belt should run in an SP-profile sheave. A similarly wide classical or narrow-wedge belt may sit at the wrong depth and change the effective drive ratio or tension. If the machine has mixed or replacement pulleys, verify the pulley markings instead of assuming the belt standard from the machine’s country of origin.

Shop metric SP belts

Browse stocked SPZ, SPA, SPB and SPC metric belts.

Recommended Parts for This Guide

4 parts we recommend — in stock, ships fast, one-click add to cart.

Metric V-belt FAQs

Can I convert an SP belt number directly to inches?

Do not assume a direct conversion. Confirm the specified length basis and cross-section against the drive standard.

Can I use an SPA belt in an SPB pulley?

No. Match the profile code to the pulley groove before comparing length.