Skip to main content
(828) 649-7190
Same Day Shipping Before 2pm EST

Poly-V Belt Size Guide: J and K Micro-Rib Profiles

Learn to identify a Poly-V micro-rib belt by J or K profile, rib count and length, and avoid mismatching the pulley grooves.

A Poly-V belt—also called a micro-rib or multi-rib belt—has many small lengthwise ribs that run in matching grooves. The format can transmit power in a compact drive and bend around smaller pulleys than a similarly rated conventional V-belt. Correct selection depends on the rib profile, rib count and belt length together.

Read a Poly-V belt marking

Many J- and K-section part numbers combine a length designation with a profile letter and rib count. For example, 240J4 identifies a stocked J-section micro-rib belt; the exact manufacturer’s marking convention should be checked for the specific series. Count the grooves on the pulley and the ribs on the belt. A belt with too few ribs will not cover the sheave properly; too many can overhang.

J vs. K Poly-V profiles

J and K are different rib profiles, not interchangeable size labels. Their rib geometry and pitch are designed for corresponding pulley grooves. Confirm the profile from the old belt marking or equipment specification, then count ribs and confirm length. Do not identify a profile from overall belt width alone.

Measure a micro-rib belt

  1. Clean the belt and record every marking, including the final rib-count code.
  2. Count pulley grooves and belt ribs.
  3. Confirm J or K profile from the marking or manufacturer data.
  4. Use the specified length basis; a flexible tape around a worn belt is only an estimate.
  5. Inspect groove cleanliness, alignment and tension before installation.

Poly-V vs. conventional V-belt

A conventional V-belt has one trapezoidal section; a Poly-V belt has several narrow ribs across one belt. They require different sheaves. A Poly-V belt is not a multi-belt replacement for several V-belts unless the complete drive was designed for that system.

Shop J-section and K-section belts

Browse J-section micro-rib belts and K-section micro-rib belts.

Recommended Parts for This Guide

2 parts we recommend — in stock, ships fast, one-click add to cart.

Poly-V belt FAQs

Can I replace a J-section belt with a K-section belt?

No. Match the exact rib profile and pulley grooves, then confirm rib count and length.

Does the last number always mean rib count?

Many common markings use a final rib-count suffix, but formats vary. Confirm the belt series or supplier specification before ordering.